SAWPARK INFORMATION CENTER

Dear Guests,

Please find below our information guides covering parking fees, parking duration, complimentary airport shuttle service, shuttle meeting points, and step-by-step return directions.

Parking Fees and Duration

Our parking rate is 250 TL per 24 hours. Please refer to the image below for detailed information about parking duration, fees, and the additional two-hour allowance applicable to the final day.

Traffic Delay Notice

Our complimentary airport shuttle normally takes approximately 5 minutes to reach Sabiha Gökçen Airport from our parking facility. Travel times may be longer during heavy traffic. Please allow sufficient time before your flight.

Shuttle Meeting Point

Our complimentary airport shuttle drops off and picks up passengers at the same designated meeting point on the Departures Level of Sabiha Gökçen Airport, in the central lane opposite the East Entrance, next to the SAWKOOP booth. Please proceed to this location when returning to our parking facility.

When Should You Call for the Shuttle?

Upon your return to Sabiha Gökçen Airport, please proceed to our designated shuttle meeting point near the green pillar marked number 6. If our shuttle vehicle is not waiting there, please call us to request a pickup. To avoid unnecessary waiting, please contact us only after reaching the meeting point.

Return Shuttle – Step-by-Step Directions

Step-by-Step Directions to the Airport Shuttle Pickup Point

1. After getting off the plane, enter the terminal building.

2. After collecting your luggage and leaving the baggage claim area, turn right.

3. Take the escalator in the right-hand corner to the upper floor (Departures Level).

4. Walk past the car rental counters and exit through the doors on your right.

5. Cross the pedestrian crossing. You will see the green pillar marked with number 6 directly ahead.

6. Turn right into the central lane.

7. When you reach the SAWKOOP booth, you can board our shuttle directly if it is already there. If our shuttle is not there, scan the SawPark QR code displayed on the booth window to request our complimentary shuttle service.

Shuttle Request Information

When requesting a shuttle, you will need to enter your vehicle’s license plate number, phone number, and number of passengers. You must also enable location services on your phone to verify your pickup location.

QR Code Queue System

During busy hours, the QR code system also determines your boarding order.

You do not need to physically wait in line. Your shuttle request will be added to the queue in the order it was submitted through the QR system.

Our shuttle driver will pick up passengers according to this queue order.

If you experience any issues, you can call us directly for assistance.